Home › TRANSMISSION ยท EA64F MANUAL TRANSAXLE › INPUT SHAFT

INPUT SHAFT > INSPECTION

for Preparation Click here



1. INSPECT INPUT SHAFT


    C113554
  1. Check the input shaft for wear and damage.

  1. Using a dial indicator, measure the shaft runout.

    Maximum runout:
    0.03 mm (0.0012 in.)

    If the runout exceeds the maximum, replace the input shaft.



    C112446E01
  1. Using a micrometer, measure the diameter of the input shaft journal surface.

    Standard diameter:
    Measured Part
    Specified Condition
    A
    30.008 to 30.020 mm (1.1814 to 1.1819 in.)
    B
    32.002 to 32.018 mm (1.2599 to 1.2605 in.)

    If the diameter is not as specified, replace the input shaft.