Home › TRANSMISSION ยท EA64 MANUAL TRANSAXLE › INPUT SHAFT

INPUT SHAFT > INSPECTION

for Preparation Click here



1. INSPECT INPUT SHAFT


    C113554
  1. Check the input shaft for wear and damage.

  1. Using a dial indicator, measure the input shaft runout.

    Maximum runout:
    0.03 mm (0.00118 in.)

    If the runout is more than the maximum, replace the input shaft.



    C112446E01
  1. Using a micrometer, measure the outer diameter of the input shaft journal surface.

    Standard Outer Diameter:
    Item
    Specified Condition
    A
    30.008 to 30.020 mm (1.1815 to 1.1818 in.)
    B
    32.002 to 32.018 mm (1.2600 to 1.2604 in.)

    If the outer diameter is less than the minimum, replace the input shaft.