INPUT SHAFT > DISASSEMBLY |
| 1. REMOVE INPUT SHAFT REAR BEARING SHAFT SNAP RING |
![]() |
Using a snap ring expander, remove the input shaft rear bearing shaft snap ring from the input shaft.
| 2. REMOVE INPUT SHAFT REAR RADIAL BALL BEARING |
![]() |
Using SST, remove the input shaft rear radial ball bearing from the input shaft.
| 3. REMOVE 6TH DRIVE GEAR |
![]() |
Using SST and a press, press out the 6th drive gear from the input shaft.
| 4. REMOVE 3RD DRIVE GEAR |
![]() |
Using SST and a press, press out the 3rd drive gear from the input shaft.
![]() |
Remove the input shaft spacer from the input shaft.
| 5. REMOVE 4TH DRIVE GEAR |
![]() |
Using SST and press, press out the 4th drive gear from the input shaft.
| 6. REMOVE INPUT SHAFT SNAP RING |
![]() |
Using 2 screwdrivers and a hammer, tap out the input shaft snap ring from the input shaft.
| 7. REMOVE INPUT SHAFT FRONT BEARING |
![]() |
Using SST and press, press out the input shaft front bearing from the input shaft.