Home › TRANSMISSION ยท EA64 MANUAL TRANSAXLE › INPUT SHAFT

INPUT SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE INPUT SHAFT REAR BEARING SHAFT SNAP RING


    C112390
  1. Using a snap ring expander, remove the input shaft rear bearing shaft snap ring from the input shaft.



2. REMOVE INPUT SHAFT REAR RADIAL BALL BEARING


    C112391E01
  1. Using SST, remove the input shaft rear radial ball bearing from the input shaft.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04011, 09957-04010, 09958-04011)
    09631-20031  



3. REMOVE 6TH DRIVE GEAR


    C117922E01
  1. Using SST and a press, press out the 6th drive gear from the input shaft.

    SST
    09950-00020  



4. REMOVE 3RD DRIVE GEAR


    C117923E01
  1. Using SST and a press, press out the 3rd drive gear from the input shaft.

    SST
    09950-00020  



    C112450
  1. Remove the spacer from the input shaft.



5. REMOVE 4TH DRIVE GEAR


    C112393E01
  1. Using SST and a press, press out the 4th drive gear from the input shaft.

    SST
    09950-00020  



6. REMOVE INPUT SHAFT SNAP RING


    C112473
  1. Using 2 screwdrivers and a hammer, tap out the snap ring from the input shaft.



7. REMOVE INPUT SHAFT FRONT BEARING


    C112394E01
  1. Using SST and a press, remove the front bearing from the input shaft.

    SST
    09950-00020