Home › TRANSMISSION ยท EA64F MANUAL TRANSAXLE › INPUT SHAFT

INPUT SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL INPUT SHAFT FRONT BEARING


    C112447E01
  1. Using SST and a press, press the input shaft front bearing into the input shaft.

    SST
    09608-00071  



2. INSTALL INPUT SHAFT SNAP RING


    C112448
  1. Using a brass bar and hammer, tap the snap ring onto the input shaft.



3. INSTALL 4TH DRIVE GEAR


    C112449E01
  1. Using SST and a press, press the 4th drive gear into the input shaft.

    SST
    09309-14040  



4. INSTALL 3RD DRIVE GEAR


    C112450
  1. Install the input shaft spacer into the input shaft.



    C112451E01
  1. Using SST and a press, press the 3rd drive gear into the input shaft.

    SST
    09309-14040  



5. INSTALL 6TH DRIVE GEAR


    C112452E01
  1. Using SST and a press, press the 6th drive gear into the input shaft.

    SST
    09309-14040  



6. INSTALL INPUT SHAFT REAR RADIAL BALL BEARING


    C112454E01
  1. Using SST and a press, press the input shaft rear radial ball bearing into the input shaft.

    SST
    09506-30012  



7. INSTALL INPUT SHAFT REAR BEARING SHAFT SNAP RING


    C118745E02
  1. Using the table below, select a new snap ring that makes the thrust clearance of the input shaft bearing less than 0.1 mm (0.0039 in.).

    Standard snap ring thickness:
    Mark
    Thickness
    Mark
    Thickness
    A
    1.80 to 1.85 mm (0.0709 to 0.0728 in.)
    3
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    B
    1.85 to 1.90 mm (0.0728 to 0.0748 in.)
    4
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    C
    1.90 to 1.95 mm (0.0748 to 0.0768 in.)
    5
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)
    D
    1.95 to 2.00 mm (0.0768 to 0.0787 in.)
    6
    2.35 to 2.40 mm (0.0925 to 0.0945 in.)
    E
    2.00 to 2.05 mm (0.0787 to 0.0807 in.)
    F
    2.40 to 2.45 mm (0.0945 to 0.0965 in.)
    0
    2.05 to 2.10 mm (0.0807 to 0.0827 in.)
    G
    2.45 to 2.50 mm (0.0965 to 0.0984 in.)
    1
    2.10 to 2.15 mm (0.0827 to 0.0846 in.)
    H
    2.50 to 2.55 mm (0.0984 to 0.1004 in.)
    2
    2.15 to 2.20 mm (0.0846 to 0.0866 in.)
    -
    -



    C112390
  1. Using a snap ring expander, install the snap ring into the input shaft.