INPUT SHAFT > REASSEMBLY |
| 1. INSTALL INPUT SHAFT FRONT BEARING |
![]() |
Using SST and a press, press in the front bearing into the input shaft.
| 2. INSTALL INPUT SHAFT SNAP RING |
![]() |
Using a brass bar and hammer, tap a new snap ring onto the input shaft.
| 3. INSTALL 4TH DRIVE GEAR |
![]() |
Using SST and a press, press in the 4th drive gear into the input shaft.
| 4. INSTALL 3RD DRIVE GEAR |
![]() |
Install the spacer into the input shaft.
![]() |
Using SST and a press, press in the 3rd drive gear into the input shaft.
| 5. INSTALL 6TH DRIVE GEAR |
![]() |
Using SST and a press, press in the 6th drive gear into the input shaft.
| 6. INSTALL INPUT SHAFT REAR RADIAL BALL BEARING |
![]() |
Using SST and a press, press in the input shaft rear radial ball bearing into the input shaft.
| 7. INSTALL INPUT SHAFT REAR BEARING SHAFT SNAP RING |
![]() |
Select a new snap ring, using the table below, that makes the thrust clearance of the input shaft bearing less than 0.1 mm (0.00394 in.).
| Mark | Specified Condition | Mark | Specified Condition |
| A | 1.80 to 1.85 mm (0.0709 to 0.0728 in.) | 3 | 2.20 to 2.25 mm (0.0866 to 0.0886 in.) |
| B | 1.85 to 1.90 mm (0.0728 to 0.0748 in.) | 4 | 2.25 to 2.30 mm (0.0886 to 0.0906 in.) |
| C | 1.90 to 1.95 mm (0.0748 to 0.0768 in.) | 5 | 2.30 to 2.35 mm (0.0906 to 0.0925 in.) |
| D | 1.95 to 2.00 mm (0.0768 to 0.0787 in.) | 6 | 2.35 to 2.40 mm (0.0925 to 0.0945 in.) |
| E | 2.00 to 2.05 mm (0.0787 to 0.0807 in.) | F | 2.40 to 2.45 mm (0.0945 to 0.0965 in.) |
| 0 | 2.05 to 2.10 mm (0.0807 to 0.0827 in.) | G | 2.45 to 2.50 mm (0.0965 to 0.0984 in.) |
| 1 | 2.10 to 2.15 mm (0.0827 to 0.0846 in.) | H | 2.50 to 2.55 mm (0.0984 to 0.100 in.) |
| 2 | 2.15 to 2.20 mm (0.0846 to 0.0866 in.) | - | - |
![]() |
Using a snap ring expander, install the snap ring into the input shaft.