Home › TRANSMISSION ยท EA64 MANUAL TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT DIFFERENTIAL SIDE GEAR


    C117507
  1. Coat the rotating surface of the front differential side gear with gear oil.

  1. Install the 2 front differential side gears and 2 front differential side gear thrust washers to the front differential case.



2. INSTALL FRONT DIFFERENTIAL PINION


    C083566
  1. Coat the rotating surface of the front differential pinion with gear oil.

  1. Install the 2 front differential pinion thrust washers and 2 front differential pinions from the differential case.

    HINT:
    Install the 2 front differential pinions with the front differential washers while turning the front differential pinion.



    C117493
  1. Install the No. 1 front differential pinion shaft into the differential case.



    C117494
  1. Using a 5 mm pin punch and hammer, install the front differential pinion shaft straight pin through the front differential case and the hole in the pinion shaft.



    C117495
  1. Using a hammer and chisel, stake the front differential case.



3. INSTALL FRONT DIFFERENTIAL RING GEAR


    C092888E03
  1. Clean the contact surfaces of the front differential case and ring gear.

  1. Heat the front differential ring gear to 90 to 110°C (194 to 230°F) in boiling water.



    C117489E04
  1. After the moisture on the ring gear has completely evaporated, quickly align the matchmarks on the ring gear and the differential case and install the ring gear to the differential case.
    Text in Illustration 
    *1
    Matchmark

  1. Install the 16 bolts.

    Torque:
    106 N*m{ 1081 kgf*cm , 78 ft.*lbf }



4. INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING


    C117497E01
  1. Using SST and a press, press in a new front tapered roller bearing.

    SST
    09309-14010  



5. INSTALL FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING


    C133923E01
  1. Using SST and a press, press in a new rear tapered roller bearing.

    SST
    09554-22010