Home › BODY › EXTERIOR › BACK DOOR OUTSIDE GARNISH (w/ Tire Carrier)

BACK DOOR OUTSIDE GARNISH (w/ Tire Carrier) > REMOVAL

for Preparation Click here



1. REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY LH
  1. Put protective tape around the back door outside garnish.

  1. Remove the screw.



  1. Remove the back door outside garnish.



    1. Using a moulding remover, detach the clips and remove the back door outside garnish.


      B209954E01

  1. w/ License Plate Light:
    Disconnect the license plate light connector.

  1. w/ Rear Fog Light:
    Disconnect the rear fog light connector.



  1. Remove the clips from the back door panel.

    1. Using a clip remover, remove the clip labeled A.



    2. Turn the remaining clips 90° as shown in the part of the illustration labeled B, and remove them.


      B209955E01



2. REMOVE BACK DOOR GARNISH COVER (for 1-piece Type)


    B208325
  1. Detach the 2 claws and remove the back door garnish cover.



3. REMOVE LICENSE PLATE LIGHT ASSEMBLY (w/ License Plate Light)
  1. Disconnect the connector.



    B132930E02
  1. Using a screwdriver, remove the light as shown in the illustration.



4. REMOVE REAR FOG LIGHT ASSEMBLY (w/ Rear Fog Light)


B132932
  1. Remove the 2 screws and rear fog light.

  1. Disconnect the connector.



5. REMOVE UPPER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY LH


B208684
  1. Remove the screw.

  1. Using a moulding remover, detach the 6 clips and remove the back door outside garnish.



    B208685E01
  1. Using a clip remover, remove the 2 clips labeled A.

  1. Turn the remaining clips 90° as shown in the part of the illustration labeled B, and remove them.



6. REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY RH


B208681
  1. Detach the 5 clips and claw, and remove the back door outside garnish.



    B208682E01
  1. Using a clip remover, remove the clip labeled A.

  1. Turn the remaining clips 90° as shown in the part of the illustration labeled B, and remove them.



7. REMOVE UPPER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY RH


B208687
  1. Detach the 6 clips and remove the back door outside garnish.



    B208688E01
  1. Using a clip remover, remove the 2 clips labeled A.

  1. Turn the remaining clips 90° as shown in the part of the illustration labeled B, and remove them.