FUEL INJECTOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE COVER |
![]() |
Detach the 4 clips and remove the engine cover.
| 3. DISCONNECT ENGINE WIRE |
![]() |
Disconnect the vacuum regulating valve connector.
Disconnect the vacuum switching valve connector.
Disconnect the 4 injector connectors.
Remove the grommet and nut, and disconnect the glow plug wire harness.
Disconnect the fuel pressure sensor connector.
Disconnect the emission control valve wire connector.
Disconnect the pressure discharge valve connector.
Remove the bolt and disconnect the engine wire from the bracket.
Remove the bolt and 5 nuts, and disconnect the engine wire.
| 4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Detach the clamp and disconnect the mass air flow meter connector.
Disconnect the PCV hose.
Disconnect the air cleaner hose.
Detach the 3 clips and remove the air cleaner cap.
| 5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 6. REMOVE AIR CLEANER CASE |
![]() |
Detach the clamp.
Remove the 3 bolts and air cleaner case.
| 7. REMOVE INJECTION PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and 4 injection pipe clamps.
Using a 14 mm union nut wrench, loosen the 4 nuts at the common rail end of the injection pipes.
Using a 14 mm union nut wrench, loosen the 4 nuts at the injector end of the injection pipes.
Remove the 4 injection pipes.
| 8. REMOVE FUEL HOSE PROTECTOR (for DPF) |
![]() |
Disconnect the connector.
![]() |
Remove the bolt and fuel hose protector.
| 9. REMOVE FUEL TUBE SUB-ASSEMBLY (for DPF) |
![]() |
Disconnect the exhaust fuel addition injector connector.
![]() |
Turn the retainer as shown in the illustration.
![]() |
Disconnect the fuel tube from the exhaust fuel addition injector.
![]() |
Remove the check valve and gasket.
| *1 | Check Valve |
Remove the union bolt, gasket and fuel tube.
| 10. REMOVE NO. 2 FUEL PIPE (for CCo) |
![]() |
Remove the check valve and gasket.
| *1 | Check Valve |
Remove the union bolt, gasket and fuel pipe.
| 11. REMOVE NO. 2 NOZZLE LEAKAGE PIPE |
![]() |
Using pliers, grip the claws of the 3 clips and slide the 3 clips to disconnect the 3 fuel hoses.
![]() |
Remove the check valve and gasket.
| *1 | Check Valve |
Remove the bolt and No. 2 nozzle leakage pipe.
| 12. REMOVE NO. 1 NOZZLE LEAKAGE PIPE |
![]() |
Remove the 4 union bolts and 4 gaskets.
Remove the bolt and No. 1 nozzle leakage pipe.
| 13. REMOVE NO. 1 NOZZLE HOLDER CLAMP |
![]() |
Remove the 4 bolts, 4 washers and 4 nozzle holder clamps.
| 14. REMOVE INJECTOR ASSEMBLY |
Remove the 4 injectors and 4 injection nozzle seats from the cylinder head.
Remove the O-ring from each injector.