COMMON RAIL > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE COVER |
![]() |
Detach the 4 clips and remove the engine cover.
| 3. DISCONNECT ENGINE WIRE |
![]() |
Disconnect the vacuum regulating valve connector.
Disconnect the vacuum switching valve connector.
Disconnect the 4 injector connectors.
Remove the grommet and nut, and disconnect the glow plug wire harness.
Disconnect the fuel pressure sensor connector.
Disconnect the emission control valve wire connector.
Disconnect the pressure discharge valve connector.
Remove the bolt and disconnect the engine wire from the bracket.
Remove the bolt and 5 nuts, and disconnect the engine wire.
| 4. REMOVE FUEL INLET PIPE SUB-ASSEMBLY |
![]() |
Remove the nut and 2 clamps.
Using a 14 mm union nut wrench, remove the fuel inlet pipe.
| 5. REMOVE INJECTION PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and 4 injection pipe clamps.
Using a 14 mm union nut wrench, loosen the 4 nuts at the common rail end of the injection pipes.
Using a 14 mm union nut wrench, loosen the 4 nuts at the injector end of the injection pipes.
Remove the 4 injection pipes.
| 6. REMOVE COMMON RAIL ASSEMBLY |
![]() |
Using pliers, grip the claws of the clip and slide the clip to disconnect the fuel hose.
Remove the 2 bolts and common rail.