PRE-HEATING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK ILLUMINATION DURATION OF GLOW INDICATOR LIGHT |
Turn the ignition switch to ON and measure the duration of time that the light remains illuminated.

| Engine Coolant Temperature | Specified Condition |
| -20°C (-4°F) | 10 to 12 seconds |
| -15°C (5°F) | 6.0 to 8.0 seconds |
| 0°C (32°F) | 3.0 to 5.0 seconds |
| 35°C (95°F) | 0.45 to 1.0 seconds |
| 2. CHECK PRE-HEATING |
Turn the ignition switch to ON and measure the length of time that battery voltage is applied to the glow plugs.

| Engine Coolant Temperature | Pre-Heating Time |
| 40°C (104°F) or higher | 1 seconds |
| 40°C (104°F) or less | Refer to the graph*1 (Maximum 15 seconds) |
| 3. CHECK AFTER GLOW TIME |
![]() |
Remove the glow plug relay.
After the engine starts, measure the length of time that battery voltage remains present.

| Tester Connection | Condition | Specified Condition |
| B43-2 - Body ground | After engine starts | Refer to graph above |