Home › ENGINE ยท 2AD-FTV › STARTING › PRE-HEATING SYSTEM

PRE-HEATING SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here


NOTICE:
Turn the ignition switch off for 60 seconds before performing the following inspections.



1. CHECK ILLUMINATION DURATION OF GLOW INDICATOR LIGHT


  1. Turn the ignition switch to ON and measure the duration of time that the light remains illuminated.


    A216128E01

    Light illumination duration:
    Refer to the graph and table

    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.

    Standard Light Illumination Time:

    Engine Coolant Temperature
    Specified Condition
    -20°C (-4°F)
    10 to 12 seconds
    -15°C (5°F)
    6.0 to 8.0 seconds
    0°C (32°F)
    3.0 to 5.0 seconds
    35°C (95°F)
    0.45 to 1.0 seconds



2. CHECK PRE-HEATING


  1. Turn the ignition switch to ON and measure the length of time that battery voltage is applied to the glow plugs.


    A216129E01


    Standard Pre-Heating Time:

    Engine Coolant Temperature
    Pre-Heating Time
    40°C (104°F) or higher
    1 seconds
    40°C (104°F) or less
    Refer to the graph*1
    (Maximum 15 seconds)

    *1: Pre-heating time changes depending on battery voltage.
    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.



3. CHECK AFTER GLOW TIME


    A209887E01
  1. Remove the glow plug relay.



  1. After the engine starts, measure the length of time that battery voltage remains present.


    A216131E01


    Standard After Glow Time:

    Tester Connection
    Condition
    Specified Condition
    B43-2 - Body ground
    After engine starts
    Refer to graph above

    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.