Home › ENGINE ยท 2AD-FTV › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER MAGNETIC SWITCH ASSEMBLY


    A165164
  1. Remove the nut and disconnect the lead wire from the starter magnetic switch.



    A165165
  1. Remove the 2 nuts and starter magnetic switch.



2. REMOVE STARTER DRIVE HOUSING ASSEMBLY


    A165166
  1. Using a T30 "TORX" driver, remove the 2 bolts.

  1. Pull out the yoke and starter commutator end frame assembly together with the armature together with the starter armature assembly.

  1. Remove the starter pinion drive lever.



3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    A165167
  1. Remove the 2 screws and end frame.

    NOTICE:
    While holding down the lead wire, remove the starter commutator end frame.



4. REMOVE STARTER ARMATURE ASSEMBLY


    A030137
  1. Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.

  1. Disconnect the 4 brushes, and remove the brush holder.



    A165174
  1. Remove the starter armature from the yoke.



5. REMOVE STARTER YOKE ASSEMBLY
  1. Remove the starter yoke from the starter center bearing clutch.



6. REMOVE STARTER ARMATURE PLATE
  1. Remove the starter armature plate from the starter center bearing clutch.



7. REMOVE PLANETARY GEAR


    A087891
  1. Remove the 3 planetary gears.