Home › ENGINE ยท 2AD-FTV › STARTING › STARTER

STARTER > REASSEMBLY

for Preparation Click here




1. INSTALL PLANETARY GEAR


    A213282
  1. Apply high-temperature grease to the planetary gears of the planetary shaft.

  1. Install the 3 planetary gears.



2. INSTALL STARTER ARMATURE PLATE


    A086452E04
  1. Insert the plate to the starter center bearing clutch.

  1. Check that the notch of the starter armature plate fits over the protrusion of the starter center bearing clutch.



3. INSTALL STARTER ARMATURE ASSEMBLY
  1. Install the starter armature to the starter center bearing clutch.



4. INSTALL STARTER YOKE ASSEMBLY


    A165179
  1. Align the tab of the starter center bearing clutch with the notch of the starter yoke, and install the starter yoke.



5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
  1. Install the starter brush holder.



    A030137
  1. Using a screwdriver, hold the brush spring back and connect the brush into the brush holder.

  1. Connect the 4 brushes.



    A213283E01
  1. Align the starter commutator end frame rubber with the groove of the starter yoke.



    A165167
  1. Install the starter commutator end frame with the 2 screws.

    Torque:
    3.8 N*m{ 39 kgf*cm , 33 in.*lbf }



6. INSTALL STARTER DRIVE HOUSING ASSEMBLY
  1. Apply high-temperature grease to the starter pinion drive lever.

  1. Install the starter pinion drive lever to the starter center bearing clutch.



    A213284E01
  1. Align the protrusion of the starter center bearing clutch with the notch inside the starter drive housing, and install the starter center bearing clutch to the starter drive housing.



    A165166
  1. Using a T30 "TORX" driver, install the starter drive housing with the 2 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



7. INSTALL STARTER MAGNETIC SWITCH ASSEMBLY


    A165165
  1. Install the starter magnetic switch with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



    A165164
  1. Connect the lead wire to the terminal with the nut.

    Torque:
    6.5 N*m{ 66 kgf*cm , 57 in.*lbf }