Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 3 HEATER TO REGISTER DUCT


    E127161
  1. Detach the 6 claws and remove the heater to register duct.



2. REMOVE AIR DUCT


    E126460
  1. Detach the 2 claws and remove the air duct.



3. REMOVE AIR OUTLET CONTROL SERVO MOTOR (for Automatic Air Conditioning System)


    E127171
  1. Remove the 3 screws.

  1. Detach the evaporator case from the blower case.



    E124277
  1. Remove the 3 screws and disconnect the connector.

  1. Remove the air outlet control servo motor.



4. REMOVE AIR MIX CONTROL SERVO MOTOR (for Automatic Air Conditioning System)


    E124276
  1. Remove the 3 screws and disconnect the connector.

  1. Remove the air mix control servo motor.



5. REMOVE MODE CONTROL CABLE ASSEMBLY (for Manual Air Conditioning System)


    E127171
  1. Remove the 3 screws.

  1. Detach the evaporator case from the blower case.



    H102208
  1. Detach the 3 claws and remove the cable.



6. REPAIR AIRMIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)


    H102209
  1. Detach the 3 claws and remove the cable.



7. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY


    E124279
  1. Remove the screw and remove the clamp.

  1. Remove the heater radiator unit.



8. REMOVE COOLER EXPANSION VALVE


    E124278
  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.

  1. Remove the cooler expansion valve and 2 O-rings from the cooler evaporator.



9. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    E124280
  1. Remove the 4 screws.

  1. Detach the 2 claws and remove the cover.



    E124281
  1. Detach the cooler thermistor clamp.

  1. Remove the cooler thermistor and cooler evaporator from the case.



10. REMOVE EVAPORATOR TEMPERATURE SENSOR


    E124282
  1. Disconnect the cooler thermistor clamp from the cooler evaporator.