Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND PULLEY (for 2AD-FHV)

COMPRESSOR AND PULLEY (for 2AD-FHV) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE


    H102041
  1. Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    H102038
  1. Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



5. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 10 clips and engine under cover.



6. REMOVE FAN & GENERATOR V BELT


  1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the belt.

    SST
    09216-42010  

    CAUTION:
    1. Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.
    2. Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.


    NOTICE:
    Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.

    A202342E01



7. REMOVE COOLER COMPRESSOR ASSEMBLY


E126953
  1. Disconnect the connector.

  1. w/o Stud Bolt:
    Remove the 4 bolts and cooler compressor.

  1. w/ Stud Bolt:
    Remove the 3 bolts, nut and cooler compressor.