Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER

CONDENSER > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



3. REMOVE FRONT BUMPER COVER
  1. w/ Under Guard:
    Remove front bumper cover (Click here).

  1. w/o Under Guard:
    Remove front bumper cover (Click here).



4. REMOVE OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)


E186400
  1. Remove the 3 bolts and oil cooler assembly.



5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    H102042
  1. Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler condenser.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



6. DISCONNECT COOLER REFRIGERANT LIQUID PIPE


    H102043
  1. Remove the bolt and disconnect the cooler refrigerant liquid pipe from the cooler condenser.

  1. Remove the O-ring from the cooler refrigerant liquid pipe.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



7. REMOVE RADIATOR SUPPORT UPPER BRACKET


    E186401E01
  1. Remove the 2 bolts and 2 brackets.



8. REMOVE NO. 1 RADIATOR SUPPORT


E187677
  1. Remove the 4 bolts and 2 radiator supports.



9. REMOVE COOLER CONDENSER ASSEMBLY


    B135838
  1. Remove the cooler condenser.



10. REMOVE COOLER DRYER


    I030086E01
  1. Using a 14 mm socket hexagon wrench, remove the cap from the modulator.



    I032475E01
  1. Remove the O-ring from the cap.



    E050386E01
  1. Using pliers, remove the cooler dryer.