Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

DTC    58-40    GPS Antenna Error

DTC    58-41    GPS Antenna Power Source Error

DTC    80-40    GPS Antenna Error

DTC    80-41    GPS Antenna Power Source Error

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
58-40
Navigation antenna error.
  1. Navigation antenna assembly
  2. Navigation receiver assembly
58-41
An error of the power source to the navigation antenna.
80-40
Navigation antenna error.
80-41
An error of the power source to the navigation antenna.

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs (Click here).

1.CHECK NAVIGATION ANTENNA ASSEMBLY
  1. Check that the navigation antenna is securely connected to the navigation receiver assembly connector.

    OK:
    The navigation antenna is securely connected.



NG
REINSTALL NAVIGATION ANTENNA ASSEMBLY
OK


2.INSPECT NAVIGATION ANTENNA ASSEMBLY


    E179011E02
  1. Disconnect the navigation antenna connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    50 to 500 Ω



NG
REPLACE NAVIGATION ANTENNA ASSEMBLY (Click here)
OK


3.REPLACE NAVIGATION RECEIVER ASSEMBLY
  1. Replace the navigation receiver assembly with a new or normally functioning one and check if the same problem occurs again.

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same trouble occurs again.

      OK:
      The same problem does not occur.



NG
REPLACE NAVIGATION ANTENNA ASSEMBLY (Click here)
OK

END