TIRE PRESSURE WARNING SYSTEM > PRECAUTION |
| 1.IGNITION SWITCH EXPRESSIONS |
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Switch Type | |
| Ignition Switch (Position) | Engine Switch (Condition) | |
| Ignition Switch off | LOCK | Off |
| Ignition Switch on (IG) | ON | On (IG) |
| Ignition Switch on (ACC) | ACC | On (ACC) |
| Engine Start | START | Start |
| 2.TIRE PRESSURE WARNING SYSTEM PRECAUTION |
![]() |
When the tire pressure warning light turns on, immediately check the tire pressure of the tire and adjust it to the specified value. (When the tire pressure warning light circuit is open, the tire pressure warning light flashes for 1 minute and then illuminates.)
When the tire pressure warning light blinks, there is a malfunction in the system. Check for DTCs.
It is necessary to register the transmitter ID in the tire pressure warning ECU and receiver after replacing the wheel and/or tire pressure warning ECU and receiver.
When replacing the tire pressure warning ECU and receiver:
Using the Data List, read the transmitter IDs registered in the ECU and make a note of them before removing the tire pressure warning ECU and receiver.
Register the transmitter IDs after installing a new tire pressure warning ECU and receiver.
| 3.IN CASE OF TIRE AND WHEEL REPLACEMENT |
When tires and wheels are replaced, always be sure to register the transmitter ID correctly.
| 4. FAIL-SAFE FUNCTION |
When a system malfunction occurs in the tire pressure warning system, the tire pressure warning light blinks and informs the driver of the system failure.
The result of this diagnosis is stored in the tire pressure warning ECU and receiver.
Precautions about the tire pressure: