TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU |
| CHECK TIRE PRESSURE WARNING ECU AND RECEIVER |

Disconnect the E64 ECU connector.
Measure the voltage and resistance of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| IG (E64-1) - GND (E64-9) | L - W-B | IG power source | Ignition switch on (IG) | 10 to 14 V |
| Ignition switch off | Below 1 V | |||
| GND (E64-9) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the E64 ECU connector.
Measure the voltage of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| SPD (E64-3) - GND (E64-9) | V - W-B | Vehicle speed signal | Vehicle is running | Pulse generation |
| SIL (E64-4) - GND (E64-9) | W - W-B | Diagnosis tester communication line | Ignition switch on (IG), when communication is not performed with a tester | 8 to 15 V |
| IND (E64-5) - GND (E64-9) | P - W-B | Tire pressure warning light output signal | Ignition switch IG (on), tire pressure warning light ON | Below 0.5 V |
| TC (E64-10) - GND (E64-9) | G - W-B | TC terminal | When terminal TC is not connected | 8 to 15 V |