TIRE PRESSURE WARNING SYSTEM > SYSTEM DESCRIPTION |
| DESCRIPTION OF SYSTEM |
A tire pressure warning valve and transmitter is equipped with a tire pressure sensor and a transmitter and is installed in each tire wheel. The sensor measures the tire pressure and internal temperatures of the tire. Then the measured value and transmitter ID are transmitted to the tire pressure antenna on the body as radio waves, which are sent to the tire pressure warning ECU and receiver. If the transmitter ID has already been registered, the ECU compares the measured air pressure value with the standard value. When the value is less than the standard value registered in the tire pressure warning ECU and receiver, the warning light in the combination meter turns on.

| WHEN TIRE PRESSURE WARNING LIGHT IS LIT |
When the tire pressure warning light does not turn off, or when it turns on during driving, check the tire pressure. If the tire pressure warning light turns on within several hours after adjusting the tire pressure, the tire may have a slow air leak.
Under the following conditions, the system may not function properly;
The average life of the grommet of the tire pressure warning valve and transmitter is approximately 4 years, at which time it must be replaced. Retighten the valve nut if the valve is leaking air, if it is less than 4 years old, and there is no problem with the grommets.
After removing and installing the ECU or a sensor, output a diagnosis code and check that it is a normal code.
| FUNCTION OF COMPONENTS |
| Components | Function |
| Tire pressure warning valve and transmitter |
|
| Tire pressure warning antenna | Receives necessary signals from tire pressure warning valve and transmitter and transmits them to tire pressure warning ECU and receiver |
| Tire pressure warning ECU and receiver |
|
| Tire pressure warning light | Located in combination meter, it informs driver of lowered tire air pressure and system failure |