Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the power switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG).

  4. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

  5. Read the Data List by following the directions on the tester screen.


Tire Pressure Monitor 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Mode Status
Tire pressure warning system
mode/NORMAL or TEST
NORMAL: Normal mode
TEST: Test mode
-
Main Tire
Number of tire IDs to be registered/
0, 1, 2, 3, 4, or 5
0 to 4 should be displayed
-
2nd Tire
-
-
-
Select Switch
-
-
-
Vehicle Speed
Vehicle speed reading/
min.: 0 km/h (0 mph),
max.: 255 km/h (158 mph)
Actual vehicle speed
Speed indicated on the combination meter
Registered ID1 Code
Registered ID1 code/
min.: 0
max.: FFFFFFF*1
The ID No. registered in the transmitter ID1 is displayed
-
Registered ID2 Code
Registered ID2 code/
min.: 0
max.: FFFFFFF*1
The ID No. registered in the transmitter ID2 is displayed
-
Registered ID3 Code
Registered ID3 code/
min.: 0
max.: FFFFFFF*1
The ID No. registered in the transmitter ID3 is displayed
-
Registered ID4 Code
Registered ID4 code/
min.: 0
max.: FFFFFFF*1
The ID No. registered in the transmitter ID4 is displayed
-
Registered ID5 Code
Registered ID5 code/
min.: 0
max.: FFFFFFF*1
-
-
ID Transmission Status
ID code transmission status / FINISH or NOW
FINISH or NOW
-
Initialization Switch
-
-
-
ID1 Tire Inflation Pressure
ID1 tire inflation pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi)
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
Actual tire inflation pressure
If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*2
ID2 Tire Inflation Pressure
ID2 tire inflation pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi)
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
Actual tire inflation pressure
If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*2
ID3 Tire Inflation Pressure
ID3 tire inflation pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi)
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
Actual tire inflation pressure
If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*2
ID4 Tire Inflation Pressure
ID4 tire inflation pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi)
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
Actual tire inflation pressure
If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*2
ID5 Tire Inflation Pressure
ID5 tire inflation pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi)
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
-
If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*2
ID1 Temperature in Tire
ID1 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
Actual tire temperature
If -40°C (-40°F) is displayed, the data has not been received.
ID2 Temperature in Tire
ID2 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
Actual tire temperature
If -40°C (-40°F) is displayed, the data has not been received.
ID3 Temperature in Tire
ID3 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
Actual tire temperature
If -40°C (-40°F) is displayed, the data has not been received.
ID4 Temperature in Tire
ID4 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
Actual tire temperature
If -40°C (-40°F) is displayed, the data has not been received.
ID5 Temperature in Tire
ID5 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
-
If -40°C (-40°F) is displayed, the data has not been received.
ID1 Battery Voltage
ID1 battery voltage/
OVER or LESS
OVER
-
ID2 Battery Voltage
ID2 battery voltage/
OVER or LESS
OVER
-
ID3 Battery Voltage
ID3 battery voltage/
OVER or LESS
OVER
-
ID4 Battery Voltage
ID4 battery voltage/
OVER or LESS
OVER
-
ID5 Battery Voltage
ID5 battery voltage/
OVER or LESS
-
-
Select Switch Info
-
-
-
Initialization Switch Info
-
-
-
ID1 Initial Threshold of Low-pressure
ID1 initial threshold of low pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi),
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
Tire pressure after initialization
-
ID2 Initial Threshold of Low-pressure
ID2 initial threshold of low pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi),
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
Tire pressure after initialization
-
ID3 Initial Threshold of Low-pressure
ID3 initial threshold of low pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi),
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
Tire pressure after initialization
-
ID4 Initial Threshold of Low-pressure
ID4 initial threshold of low pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi),
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
Tire pressure after initialization
-
ID5 Initial Threshold of Low-pressure
ID5 initial threshold of low pressure/
min.: -100 kPa (-1 kgf/cm2, -14 psi),
max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
-
-
Engine Speed
Engine speed/
min.: 0 rpm
max.: 65535 rpm
Actual engine speed
-
Number of Trouble Code
Number of DTCs recorded/
min.: 0
max.: 255
0
-

HINT:
*1: Displayed only when the ID No. is not registered.
*2: It may take about 2 or 3 minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24.