CRUISE CONTROL SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (USING INTELLIGENT TESTER) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Read the DTCs by following the directions on the tester screen.
| CHECK DTC (USING SST CHECK WIRE) |
![]() |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the ignition switch on (IG).
![]() |
Read the DTC on the CRUISE main indicator light.
| CLEAR DTC (USING INTELLIGENT TESTER) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Read the DTCs by following the directions on the tester screen.
| CLEAR DTC (USING SST CHECK WIRE) |
Read and record DTCs from the CRUISE main indicator light. Turn the ignition switch off.
If DTCs are indicated, repair the relevant circuits using the DTC Chart (Click here).
Clear the DTCs according to one of the following procedures.
Recheck for DTCs.