TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit |

| 1.INSPECT FUSE (GAUGE2) |
Remove the GAUGE2 fuse from the instrument panel junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.CHECK TIRE PRESSURE WARNING LIGHT CIRCUIT |
![]() |
Disconnect the E64 ECU connector.
Using a service wire, connect E64-5 (IND) on the wire harness side and body ground.
Turn the ignition switch on (IG).
Check that the tire pressure warning light turns on.
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (ECU - METER) |
![]() |
Disconnect the E64 ECU connector.
Disconnect the E22 meter connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E64-5 (IND) - E22-5 (TIRE) | Below 1 Ω |
|
| ||||
| OK | ||
| ||