BACK DOOR GLASS > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR WIPER ARM ASSEMBLY |
![]() |
Widen each end of the cap 5 mm (0.19in).
![]() |
Lift the both widened ends of the cap.
![]() |
Rotate the cap. Fix the cap in place.
![]() |
Remove the nut and arm and blade.
| 3. REMOVE BACK DOOR TRIM BOARD |
![]() |
Using a screwdriver, detach the 13 clips and remove the trim board.
Remove the 5 screws and the back door trim pocket.
| 4. REMOVE BACK DOOR CENTER GARNISH |
![]() |
Using a screwdriver, detach the 4 claws and 4 clips and remove the garnish.
| 5. REMOVE BACK DOOR SIDE GARNISH LH |
![]() |
Using a screwdriver, detach the 2 claws and 2 clips and remove the garnish.
| 6. REMOVE BACK DOOR SIDE GARNISH RH |
| 7. REMOVE REAR WIPER MOTOR GROMMET |
| 8. REMOVE REAR WIPER MOTOR ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 3 bolts and wiper motor.
| 9. REMOVE REAR SPOILER |
![]() |
Remove the 3 bolts.
![]() |
Remove the 3 clips and spoiler.
Disconnect the center stop light connector and remove the rear spoiler.
| 10. REMOVE BACK WINDOW MOULDING LOWER |
![]() |
Using a knife, cut off the moulding as shown in the illustration.
Remove the remaining moulding.
| 11. REMOVE BACK WINDOW MOULDING OUTSIDE LH |
![]() |
Using a knife, cut off the moulding as shown in the illustration.
Remove the remaining moulding.
| 12. REMOVE BACK DOOR GLASS |
Disconnect the rear window defogger connector.
![]() |
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
From the interior, insert a piano wire between the vehicle body and back door glass as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
![]() |
Place matchmarks over the glass and vehicle body on the locations indicated in the illustration.
Cut through the adhesive by pulling the piano wire around the back door glass.
Using suction cups, remove the back door glass.
| 13. CLEAN BACK DOOR GLASS |
![]() |
Clean the outer edge of the back door glass with non-residue solvent.
| 14. CLEAN VEHICLE BODY |
![]() |
Using a scraper, remove the moulding and adhesive from the back door glass.
Clean and shape the contact surface of the vehicle body.
On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
Clean the contact surface of the vehicle body with cleaner.