SHIFT AND SELECT LEVER SHAFT > DISASSEMBLY |
| 1. REMOVE SELECTING BELL CRANK ASSEMBLY |
![]() |
Remove the 2 bolts and selecting bell crank from the transmission case.
| 2. REMOVE CONTROL SHIFT LEVER BUSH |
![]() |
Remove the control shift lever bush from the selecting bellcrank.
| 3. REMOVE NO. 1 SELECTING BELLCRANK DUST COVER |
![]() |
Remove the dust cover from the selecting bellcrank.
| 4. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY |
![]() |
Using SST, remove the back-up light switch and gasket.
| 5. REMOVE NO. 1 LOCK BALL ASSEMBLY |
![]() |
Remove the lock ball from the transmission case.
| 6. REMOVE NO. 2 LOCK BALL ASSEMBLY |
![]() |
Remove the lock ball from the transmission case.
| 7. REMOVE SHIFT GATE PIN |
![]() |
Remove the shift gate pin from the transmission case.
| 8. REMOVE CONTROL SHAFT COVER |
![]() |
Remove the 4 bolts and control shaft cover from the transmission case.
| 9. REMOVE NO. 1 SHIFT LEVER INNER |
![]() |
Using a pin punch and hammer, tap out the slotted spring pin from the No.1 shift lever inner.
Remove the No. 1 shift lever inner and shift inter lock plate from the shift and select lever shaft.
| 10. REMOVE SHIFT AND SELECT LEVER SHAFT |
![]() |
Remove the shift control cover and the shift and select lever boot from the shift and select lever shaft.
| 11. REMOVE SHIFT GATE PLATE |
![]() |
Remove the 2 bolts and shift gate plate from the No. 1 shift lever inner.
| 12. REMOVE PIN |
![]() |
Remove the 2 pins.
| 13. REMOVE SHIFT LEVER DAMPER |
![]() |
Remove the 2 bolts and shift lever damper from the shift lever shaft.
| 14. REMOVE CONTROL SHAFT COVER OIL SEAL |
![]() |
Using a screwdriver, pry out the oil seal from the control shaft cover.
| 15. REMOVE SHIFT FORK SHAFT BEARING |
![]() |
Using SST and a press, press out the bearing.