Home › TRANSMISSION ยท EA64 MANUAL TRANSAXLE › SHIFT AND SELECT LEVER SHAFT

SHIFT AND SELECT LEVER SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE SELECTING BELL CRANK ASSEMBLY


    C112480
  1. Remove the 2 bolts and selecting bell crank from the manual transmission case.



2. REMOVE CONTROL SHIFT LEVER BUSHING


    C113636
  1. Remove the control shift lever bushing from the selecting bell crank.



3. REMOVE NO. 1 SELECTING BELL CRANK DUST COVER


    C116207
  1. Remove the No. 1 selecting bell crank dust cover from the selecting bell crank.



4. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY


    C112471E02
  1. Using SST, remove the back-up light switch and gasket.

    SST
    09817-16011  



5. REMOVE NO. 1 TRANSMISSION CASE PLUG
  1. Using a T55 ''TORX'' socket wrench, remove the plug.



6. REMOVE NO. 1 LOCK BALL ASSEMBLY


    C116559
  1. Remove the No. 1 lock ball from the manual transmission case.



7. REMOVE NO. 2 LOCK BALL ASSEMBLY


    C116561
  1. Remove the No. 2 lock ball from the manual transmission case.



8. REMOVE SHIFT GATE PIN


    C116560
  1. Remove the shift gate pin from the manual transmission case.



9. REMOVE SHIFT AND SELECT LEVER ASSEMBLY


    C112484
  1. Remove the 4 bolts and shift and select lever assembly from the manual transmission case.



10. REMOVE INNER NO. 1 SHIFT LEVER


    C112486
  1. Using a 5 mm pin punch and hammer, remove the slotted spring pin from the inner No. 1 shift lever.



    C112482
  1. Remove the inner No. 1 shift lever and shift interlock plate from the shift and select lever shaft.



11. REMOVE SHIFT AND SELECT LEVER SHAFT
  1. Remove the control shaft cover and shift and select lever boot from the shift and select lever shaft.



12. REMOVE SHIFT GATE PLATE


    C116727
  1. Remove the 2 bolts and shift gate plate from the inner No. 1 shift lever.



13. REMOVE PIN


    C118049
  1. Remove the 2 pins.



14. REMOVE SHIFT LEVER DAMPER


    C115448
  1. Remove the 2 bolts and shift lever damper from the shift and select lever shaft.



15. REMOVE CONTROL SHAFT COVER OIL SEAL


    C112479
  1. Using a screwdriver, remove the control shaft cover oil seal from the control shaft cover.