INTERCOOLER > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (w/ Air Conditioning System) |
Start the engine.
Turn the A/C switch on.
Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Recover the refrigerant from the A/C system using a refrigerant recovery unit.
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL |
| 4. REMOVE FRONT BUMPER REINFORCEMENT |
w/ Under Guard:
Remove the front bumper reinforcement (Click here).
w/o Under Guard:
Remove the front bumper reinforcement (Click here).
| 5. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY (w/ Air Conditioning System) |
![]() |
Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler condenser.
Remove the O-ring from the cooler refrigerant discharge hose.
| 6. DISCONNECT LIQUID PIPE SUB-ASSEMBLY (w/ Air Conditioning System) |
![]() |
Remove the bolt and disconnect the cooler refrigerant liquid pipe from the cooler condenser.
Remove the O-ring from the cooler refrigerant liquid pipe.
| 7. REMOVE UPPER RADIATOR SUPPORT BRACKET |
![]() |
Remove the 9 clips and radiator support opening cover.
| 8. REMOVE NO. 1 RADIATOR SUPPORT |
![]() |
Remove the 4 bolts and 2 radiator supports.
| 9. REMOVE COOLER CONDENSER ASSEMBLY (w/ Air Conditioning System) |
![]() |
Remove the cooler condenser.
| 10. REMOVE NO. 1 ENGINE COVER |
![]() |
Detach the 4 clips and remove the engine cover.
| 11. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 6 bolts, 10 clips and engine under cover.
| 12. REMOVE REAR ENGINE UNDER COVER LH |
Remove the 2 clips and under cover.
| 13. REMOVE REAR ENGINE UNDER COVER RH |
Remove the 2 clips and under cover.
| 14. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator reservoir cap.
Loosen the cylinder block drain cock plug.

| *1 | Radiator Reservoir Cap | *2 | Radiator Reservoir |
| *3 | Cylinder Block Drain Cock | *4 | Radiator Drain Cock Plug |
| 15. REMOVE BATTERY CLAMP SUB-ASSEMBLY |
![]() |
Remove the bolt and loosen the nut.
Detach the 2 wire harness clamps.
Detach the hook of the battery clamp from the front battery bracket, and then remove the battery clamp.
| 16. REMOVE BATTERY |
| 17. REMOVE BATTERY TRAY |
| 18. REMOVE FRONT BATTERY BRACKET |
![]() |
Detach the 2 wire harness clamps.
Remove the 4 bolts and front battery bracket.
| 19. REMOVE BATTERY BRACKET REINFORCEMENT |
![]() |
Remove the 2 bolts and battery bracket reinforcement.
| 20. REMOVE WATER BY-PASS HOSE |
![]() |
Detach the water by-pass hose from the hose clamp.
Disconnect the water by-pass hose from the radiator reservoir and radiator.
Remove the 2 bolts and water by-pass hose.
| 21. REMOVE HOOD LOCK ASSEMBLY (for LHD) |
![]() |
w/ Hood courtesy switch:
Disconnect the connector.
Remove the 3 bolts.
![]() |
Disconnect the cable and remove the lock.
| 22. REMOVE HOOD LOCK ASSEMBLY (for RHD) |
![]() |
w/ Hood courtesy switch:
Disconnect the connector.
Remove the 3 bolts.
![]() |
Disconnect the cable and remove the lock.
| 23. REMOVE UPPER RADIATOR SUPPORT |
![]() |
Remove the 4 bolts and upper radiator support.
| 24. REMOVE INLET RADIATOR HOSE |
![]() |
Detach the 2 hose clamps from the fan shroud.
Remove the inlet radiator hose and disconnect the No. 5 water by-pass hose from the radiator.
| 25. REMOVE OUTLET RADIATOR HOSE |
![]() |
Remove the outlet radiator hose.
| 26. REMOVE RADIATOR AND INTERCOOLER |
![]() |
Disconnect the vacuum hose from the intake manifold.
![]() |
Disconnect the 3 connectors and detach the 9 wire harness clamps.
![]() |
Loosen the 2 clamps.
| *1 | Clamp |
Disconnect the No. 2 and No. 3 air hoses from the engine.
Remove the radiator and intercooler assembly.
![]() |
Loosen the 2 clamps.
| *1 | Clamp |
Remove the bolt.
Remove the No. 2 air tube from the intercooler and No. 3 air hose.
![]() |
Loosen the clamp.
| *1 | Clamp |
Remove the No. 2 air hose from the intercooler.
![]() |
Remove the 4 bolts and intercooler.
| *1 | Radiator |
| *2 | Intercooler |
| 27. REMOVE NO. 2 RADIATOR SUPPORT |
![]() |
Remove the 4 bolts and 2 radiator supports.