Home › ENGINE ยท 2AD-FTV › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE INTAKE VALVE

HINT:
Arrange the valves, inner compression springs, valve spring retainers and valve spring retainer locks in the correct order.

  1. Place the cylinder head on a wooden block.



    A111290E04
  1. Using SST, compress the inner compression spring and remove the valve spring retainer lock.

    SST
    09202-70020  

  1. Remove the valve spring retainer, inner compression spring, valve spring seat plate washer and intake valve.



2. REMOVE EXHAUST VALVE

HINT:
Arrange the valves, inner compression springs, valve spring retainers and valve spring retainer locks in the correct order.

  1. Place the cylinder head on a wooden block.



    A111289E04
  1. Using SST, compress the inner compression spring and remove the valve spring retainer lock.

    SST
    09202-70020  

  1. Remove the valve spring retainer, inner compression spring, valve spring seat plate washer and exhaust valve.



3. REMOVE VALVE STEM OIL SEAL


    A111291
  1. Using needle-nose pliers, remove the valve stem oil seal.



4. REMOVE VALVE SPRING SEAT PLATE WASHER


    A111292
  1. Using compressed air and a magnet hand, remove the valve spring seat plate washer by blowing air.