Home › ENGINE ยท 2AD-FHV › ENGINE CONTROL SYSTEM › MANIFOLD ABSOLUTE PRESSURE SENSOR

MANIFOLD ABSOLUTE PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK DIESEL TURBO PRESSURE SENSOR


    A162709E04
  1. Inspect the power source voltage.

    1. Disconnect the sensor connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Condition
      Specified Condition
      3 (VC) - 1 (E2)
      Ignition Switch ON
      4.5 to 5.5 V

      Text in Illustration 
      *1
      Front view of wire harness connector
      (to Diesel Turbo Pressure Sensor)

    3. Turn the ignition switch off.

    4. Reconnect the sensor connector.



  1. Check the vacuum and pressure.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Map and Atmosphere.

    5. Disconnect the vacuum hose form the sensor.



    6. A201865E03
    7. Using SST, apply pressure to the sensor.

      SST
      09992-00242  

    8. Using a vacuum pump, apply vacuum to the sensor.

    9. Read the value.

      OK:
      Condition
      Map and Atmosphere Pressure Value
      No pressure applied
      Same as atmospheric pressure
      Vacuum applied
      Becomes vacuum
      Pressure applied
      Becomes pressurized

      If the result is not as specified, replace the diesel turbo pressure sensor.