MANIFOLD ABSOLUTE PRESSURE SENSOR > ON-VEHICLE INSPECTION |
| 1. CHECK DIESEL TURBO PRESSURE SENSOR |
![]() |
Inspect the power source voltage.
Disconnect the sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 (VC) - 1 (E2) | Ignition Switch ON | 4.5 to 5.5 V |
| *1 | Front view of wire harness connector (to Diesel Turbo Pressure Sensor) |
Turn the ignition switch off.
Reconnect the sensor connector.
Check the vacuum and pressure.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Map and Atmosphere.
Disconnect the vacuum hose form the sensor.
![]() |
Using SST, apply pressure to the sensor.
Using a vacuum pump, apply vacuum to the sensor.
Read the value.
| Condition | Map and Atmosphere Pressure Value |
| No pressure applied | Same as atmospheric pressure |
| Vacuum applied | Becomes vacuum |
| Pressure applied | Becomes pressurized |