Home › ENGINE ยท 2AD-FTV › FUEL › FUEL TANK

FUEL TANK > REASSEMBLY

for Preparation Click here



1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A124670
  1. Install the sender gauge with the 5 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }



2. INSTALL NO. 1 FUEL TANK CUSHION


    A124667
  1. Install 7 new fuel tank cushions onto the fuel tank as shown in the illustration.



3. INSTALL NO. 1 FUEL TUBE CLAMP


    A125367
  1. Install the 4 fuel tube clamps to the fuel tank.



4. INSTALL FUEL TANK RETURN TUBE
  1. Install the return tube to the fuel tube clamps



5. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
  1. Install the main tube to the fuel tube clamps.



6. INSTALL FUEL SUCTION VENT TUBE ASSEMBLY


    A125360
  1. Install a new gasket onto the suction vent tube assembly.

  1. Connect the fuel hose and install the suction vent tube assembly into the fuel tank.

    NOTICE:
    Do not damage the suction vent tube assembly filter.



7. INSTALL FUEL TANK VENT TUBE SET PLATE


    A125359
  1. Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }



8. CONNECT FUEL TANK RETURN TUBE


    A209415E01
  1. Push the fuel tube joint into the plug of the fuel suction vent tube, and then install the tube joint clip.

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joint is inserted securely.
    3. Check that the fuel tube joint clip is on the collar of the fuel tube joint.
    4. After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.
    5. Be careful not to damage any clip. If a clip is damaged, replace it.



9. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A209416E01
  1. Push the fuel tube joint into the plug of the fuel suction vent tube, and then install the tube joint clip.

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joint is inserted securely.
    3. Check that the fuel tube joint clip is on the collar of the fuel tube joint.
    4. After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.
    5. Be careful not to damage any clip. If a clip is damaged, replace it.



10. INSTALL FUEL EMISSION HOSE


    A127856
  1. Connect the fuel emission hose.