CHARGING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK BATTERY CONDITION |
Check the battery for damage and deformation. If severe damage, deformation or leakage is found, replace the battery.
![]() |
Check the electrolyte quantity of each cell.
For maintenance-free batteries:
![]() |
For non-maintenance-free batteries:
| 2. CHECK BATTERY TERMINAL AND FUSE |
Check that the battery terminals are not loose or corroded.
If the terminals are corroded, clean the terminals.
Measure the resistance of the ALT fuse.
| 3. INSPECT FAN AND GENERATOR V BELT |
![]() |
Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the fan and generator V belt.
![]() |
Check that the belt fits properly in the ribbed grooves.
| 4. VISUALLY CHECK GENERATOR WIRING |
Check that the wiring is in good condition.
If the condition is not good, repair or replace the generator wire.
| 5. LISTEN FOR ABNORMAL NOISES FROM GENERATOR |
Check that there is no abnormal noise from the generator while the engine is running.
If there is abnormal noise, replace the pulley or generator.
| 6. CHECK CHARGE WARNING LIGHT CIRCUIT |
Turn the ignition switch to ON. Check that the charge warning light comes on.
Start the engine and check that the light goes off.
If the light does not operate as specified, troubleshoot the charge warning light circuit.
| 7. CHECK CHARGING CIRCUIT WITHOUT LOAD |
![]() |
According to the following procedure, connect an ammeter and voltmeter as shown in the illustration.
Disconnect the wire from terminal B of the generator and connect it to the negative (-) lead of the ammeter.
Connect the positive (+) lead of an ammeter to terminal B of the generator.
Connect the positive (+) lead of a voltmeter to terminal B of the generator.
Ground the negative (-) lead of the voltmeter.
Check the charging circuit.
While keeping the engine speed at 2000 rpm, check the readings on the ammeter and voltmeter.
| 8. CHECK CHARGING CIRCUIT WITH LOAD |
Keep the engine speed at 2000 rpm, turn on the high beam headlights, and turn the heater blower switch to the "HI" position.
Check the reading on the ammeter.