Home › ENGINE ยท 2AD-FHV › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY CAP


    A196731
  1. Using a screwdriver, puncture the center of the generator pulley cap and pry it off.

    NOTICE:
    Do not reuse the generator pulley cap.



2. REMOVE GENERATOR WITH CLUTCH PULLEY
  1. Mount the generator in a vise between aluminum plates.



    A196732E01
  1. Install SST (A) and (B) to the generator with clutch pulley as shown in the illustration.

    SST
    09820-63021  
    Text in Illustration 
    *1
    Rotor Shaft

    NOTICE:
    Securely install SST to the generator with clutch pulley and generator rotor shaft.



    A196733E01
  1. Using a wrench to hold SST (A), turn SST (B) counterclockwise to loosen the generator with clutch pulley.

    NOTICE:
    Be careful as the generator with clutch pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Remove SST from the generator.

  1. Remove the generator with clutch pulley from the rotor shaft.



3. REMOVE GENERATOR REAR END COVER


    A196734
  1. Place the generator on the generator with clutch pulley.

  1. Remove the 3 nuts and generator rear end cover.



4. REMOVE GENERATOR TERMINAL INSULATOR


    A196735
  1. Remove the generator terminal insulator from the generator coil.



5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A196736
  1. Remove the 2 screws and generator brush holder from the generator coil.



6. REMOVE GENERATOR COIL ASSEMBLY


    A196737
  1. Remove the 4 bolts from the drive end frame.



    A196738E02
  1. Using SST, remove the generator coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *1
    Hold
    *2
    Turn



7. REMOVE GENERATOR ROTOR ASSEMBLY


    A196812E01
  1. Remove the washer and generator rotor.
    Text in Illustration 
    *1
    Washer
    *2
    Generator Rotor



8. REMOVE GENERATOR DRIVE END FRAME BEARING


    A196740
  1. Remove the 4 screws and retainer plate.



    A196741E01
  1. Using SST and a hammer, tap out the generator drive end frame bearing from the generator drive end frame.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)