GENERATOR > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY CAP |
![]() |
Using a screwdriver, puncture the center of the generator pulley cap and pry it off.
| 2. REMOVE GENERATOR WITH CLUTCH PULLEY |
Mount the generator in a vise between aluminum plates.
![]() |
Install SST (A) and (B) to the generator with clutch pulley as shown in the illustration.
| *1 | Rotor Shaft |
![]() |
Using a wrench to hold SST (A), turn SST (B) counterclockwise to loosen the generator with clutch pulley.
Remove SST from the generator.
Remove the generator with clutch pulley from the rotor shaft.
| 3. REMOVE GENERATOR REAR END COVER |
![]() |
Place the generator on the generator with clutch pulley.
Remove the 3 nuts and generator rear end cover.
| 4. REMOVE GENERATOR TERMINAL INSULATOR |
![]() |
Remove the generator terminal insulator from the generator coil.
| 5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Remove the 2 screws and generator brush holder from the generator coil.
| 6. REMOVE GENERATOR COIL ASSEMBLY |
![]() |
Remove the 4 bolts from the drive end frame.
![]() |
Using SST, remove the generator coil.
| *1 | Hold |
| *2 | Turn |
| 7. REMOVE GENERATOR ROTOR ASSEMBLY |
![]() |
Remove the washer and generator rotor.
| *1 | Washer |
| *2 | Generator Rotor |
| 8. REMOVE GENERATOR DRIVE END FRAME BEARING |
![]() |
Remove the 4 screws and retainer plate.
![]() |
Using SST and a hammer, tap out the generator drive end frame bearing from the generator drive end frame.