Home › ENGINE ยท 2AD-FHV › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR DRIVE END FRAME BEARING


    A196742E01
  1. Using SST and a press, press in a new bearing.

    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)



    A196740
  1. Install the retainer plate with the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }



2. INSTALL GENERATOR ROTOR ASSEMBLY


    A196745
  1. Place the generator drive end frame on the generator pulley.

  1. Install the rotor to the generator drive end frame.



    A196739
  1. Place the washer on the rotor.



3. INSTALL GENERATOR COIL ASSEMBLY


    A196746
  1. Using a 21 mm deep socket wrench and press, slowly press in the generator coil.



    A196737
  1. Install the coil with the 4 bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }



4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    A196810E01
  1. While pushing the 2 brushes into the generator brush holder, insert a pin with a diameter of 1.0 mm (0.0394 in.) into the brush holder hole.
    Text in Illustration 
    *1
    Pin



    A196747E01
  1. Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

    Text in Illustration 
    *1
    Pin

  1. Pull out the pin from the generator brush holder.



5. INSTALL GENERATOR TERMINAL INSULATOR


    A196735
  1. Install the generator terminal insulator to the generator coil assembly.



6. INSTALL GENERATOR REAR END COVER


    A196748
  1. Install the rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 46 kgf*cm , 40 in.*lbf }



7. INSTALL GENERATOR WITH CLUTCH PULLEY
  1. Temporarily install the generator with clutch pulley.

  1. Mount the generator in a vise between aluminum plates.



    A196749E02
  1. Install SST (A) and (B) to the generator with clutch pulley as shown in the illustration.

    NOTICE:
    Securely install SST to the generator with clutch pulley and generator rotor shaft.

    SST
    09820-63021  



    A196750E03
  1. Using a wrench to hold SST (A), turn SST (B) clockwise to tighten the generator with clutch pulley.
    Text in Illustration 
    *1
    Hold
    *2
    Turn
    *3
    Fulcrum Length

    Torque:
    without SST:
    111 N*m{ 1127 kgf*cm , 81 ft.*lbf }
    with SST:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }

    NOTICE:
    1. Use a torque wrench with a fulcrum length of 400 mm (15.748 in.).
    2. This torque value is effective when SST is parallel to a torque wrench.
    3. Be careful as the generator with clutch pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Check that the generator pulley rotates smoothly.



8. INSTALL GENERATOR PULLEY CAP


    A196751
  1. Install a new generator pulley cap.