GENERATOR > REASSEMBLY |
| 1. INSTALL GENERATOR DRIVE END FRAME BEARING |
![]() |
Using SST and a press, press in a new bearing.
![]() |
Install the retainer plate with the 4 screws.
| 2. INSTALL GENERATOR ROTOR ASSEMBLY |
![]() |
Place the generator drive end frame on the generator pulley.
Install the rotor to the generator drive end frame.
![]() |
Place the washer on the rotor.
| 3. INSTALL GENERATOR COIL ASSEMBLY |
![]() |
Using a 21 mm deep socket wrench and press, slowly press in the generator coil.
![]() |
Install the coil with the 4 bolts.
| 4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
While pushing the 2 brushes into the generator brush holder, insert a pin with a diameter of 1.0 mm (0.0394 in.) into the brush holder hole.
| *1 | Pin |
![]() |
Install the generator brush holder with the 2 screws.
| *1 | Pin |
Pull out the pin from the generator brush holder.
| 5. INSTALL GENERATOR TERMINAL INSULATOR |
![]() |
Install the generator terminal insulator to the generator coil assembly.
| 6. INSTALL GENERATOR REAR END COVER |
![]() |
Install the rear end cover with the 3 nuts.
| 7. INSTALL GENERATOR WITH CLUTCH PULLEY |
Temporarily install the generator with clutch pulley.
Mount the generator in a vise between aluminum plates.
![]() |
Install SST (A) and (B) to the generator clutch pulley as shown in the illustration.
![]() |
Using a wrench to hold SST (A), turn SST (B) clockwise to tighten the generator with clutch pulley.
| *1 | Hold |
| *2 | Turn |
| *3 | Fulcrum Length |
Check that the generator with clutch pulley rotates smoothly.
| 8. INSTALL GENERATOR PULLEY CAP |
![]() |
Install a new generator pulley cap.