Home › ENGINE · 2AD-FHV › CHARGING › BATTERY CURRENT SENSOR

BATTERY CURRENT SENSOR > INSPECTION

for Preparation Click here



1. CHECK BATTERY CURRENT SENSOR ASSEMBLY


  1. Check the battery current sensor assembly.



      A197926E03
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 (VC5) - 4 (E2)
      Always
      3 to 10 kΩ
      2 (VC5) - 3 (IB)
      Always
      Below 0.5 kΩ
      3 (IB) - 4 (E2)
      Always
      3 to 10 kΩ

      If the result is not as specified, replace the battery current sensor assembly.



  1. Check the battery temperature sensor.



      A197925E03
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (THB) - 4 (E2)
      20 to 30°C (68 to 86°F)
      1.5 to 2.5 kΩ

      HINT:
      1. As the temperature increases, the resistance decreases (refer to the graph).
      2. The battery temperature sensor is part of the battery current sensor.

      If the result is not as specified, replace the battery current sensor assembly.