Home › ENGINE · 2AD-FTV › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT POSITION SENSOR


    A103051E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Cold
    835 to 1400 Ω
    Hot
    1060 to 1645 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Camshaft Position Sensor)

    NOTICE:
    In the table above, the terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

    If the result is not as specified, replace the camshaft position sensor.