Home › ENGINE ยท 2AD-FTV › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



2. REMOVE RADIATOR RESERVOIR ASSEMBLY


    A124930
  1. Remove the 2 bolts and reservoir.



3. REMOVE RADIATOR RESERVOIR BRACKET


    A124931
  1. Remove the bolt and bracket.



4. REMOVE CAMSHAFT POSITION SENSOR


    A205276
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.