Home › ENGINE ยท 2AD-FHV › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to detach both the front and rear clips at the same time may cause the cover to break.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A208830
  1. Detach the clamp and disconnect the mass air flow meter connector.

  1. Disconnect the PCV hose.

  1. Disconnect the air cleaner hose.

  1. Detach the 3 clips and remove the air cleaner cap.



3. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


4. REMOVE AIR CLEANER CASE


    A208831
  1. Detach the clamp.

  1. Remove the 3 bolts and air cleaner case.



5. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the cylinder block drain cock plug.

    HINT:
    The plug is on the backside of the generator on the EGR cooler side.



    A208259E01


    Text in Illustration 
    *1
    Radiator Reservoir Cap
    *2
    Radiator Reservoir
    *3
    Cylinder Block Drain Cock
    *4
    Radiator Drain Cock Plug



6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A204311E02
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor and gasket.

    SST
    09817-33190