Home › ENGINE ยท 2AD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR

INTAKE AIR TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL INTAKE AIR TEMPERATURE SENSOR


    A209816
  1. Install a new gasket to the sensor.

  1. Using a 22 mm ball joint lock nut wrench, install the sensor.

    Torque:
    34 N*m{ 350 kgf*cm , 25 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench (Click here).

  1. Connect the sensor connector.



2. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 6 bolts and 10 clips.