Home › ENGINE · 2AD-FHV › ENGINE CONTROL SYSTEM › DIESEL THROTTLE BODY

DIESEL THROTTLE BODY > INSPECTION

for Preparation Click here



1. INSPECT DIESEL THROTTLE BODY ASSEMBLY


A204366E02
  1. Check that the throttle valve opens and closes smoothly.

  1. Check that the there is no sludge accumulating around the throttle body.

    NOTICE:
    When cleaning the throttle body, use a piece of cloth soaked with cleaning solvent. Spraying the solvent directly onto this part or soaking the part in solvent may damage it.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (M-) - 2 (M+)
    20°C (68°F)
    0.3 to 100 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Diesel Throttle Body)

    NOTICE:
    Be sure to move the throttle valve when measuring the resistance.

    If the result is not as specified, replace the diesel throttle body assembly.