DIESEL THROTTLE BODY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE COVER |
![]() |
Detach the 4 clips and remove the engine cover.
| 3. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 6 bolts, 10 clips and engine under cover.
| 4. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator reservoir cap.
Loosen the cylinder block drain cock plug.

| *1 | Radiator Reservoir Cap | *2 | Radiator Reservoir |
| *3 | Cylinder Block Drain Cock | *4 | Radiator Drain Cock Plug |
| 5. REMOVE NO. 3 AIR HOSE |
![]() |
Loosen the 2 hose clamps.
Remove the No. 3 air hose from the No. 2 air tube and throttle body.
| 6. REMOVE DIESEL THROTTLE BODY ASSEMBLY |
![]() |
Disconnect the No. 7 water by-pass hose from the throttle body.
Disconnect the No. 6 water by-pass hose from the throttle body.
Disconnect the throttle position sensor and throttle motor connector.
![]() |
Remove the 2 nuts, 2 bolts, diesel throttle body and gasket.