FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PRESSURE |
Read Data List
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
Read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition |
| Fuel Press | Fuel pressure/ Min.: 0 kPa, Max.: 250000 kPa | Idling: 27000 to 37000 kPa |
| Target Common Rail Pressure | Target common rail pressure/ Min.: 0 kPa, Max.: 250000 kPa | 25000 to 180000 kPa when engine running |
| 2. INSPECT FOR FUEL LEAK |
Perform Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
Perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Notes |
| Test the Fuel Leak | Pressurizes common rail internal fuel pressure, and checks for fuel leaks | Stop/Start | Performs inspection of the high pressure fuel system.
|
| 3. CHECK PRESSURE DISCHARGE VALVE |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
![]() |
Turn the intelligent tester ON.
Enter the following menus: Powertrain /Engine / Utility / Pressure Discharge Valve Check.
![]() |
Press "Next".
![]() |
Press "Next" again to proceed.
![]() |
Select the "Close to Open Check".
Press "Next".
Read the value of "Open and Engine OFF".


| 4. BLEED AIR FROM FUEL SYSTEM |
![]() |
Using the hand pump mounted on the fuel filter cap, bleed the air from the fuel system. Continue pumping until the pump resistance increases.
Start the engine.
When the engine can be started, proceed to the next step.
If the engine cannot be started, bleed the air again using the hand pump until the hand pump resistance increases (refer to the procedures above). Then start the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Clear DTCs (Click here).
Start the engine.*1
![]() |
Enter the following menus: Powertrain / Engine and ECT / Active Test / Test the Fuel Leak.*2
Perform the following test 5 times with on/off intervals of 10 seconds: Active Test / Test the Fuel Leak.*3
Allow the engine to idle for 3 minutes or more after performing the Active Test for the fifth time.

Enter the following menus: Powertrain / Engine and ECT / DTC.
Read Current DTCs.
When no DTCs are output, the air bleeding is completed.
If any DTCs are output, proceed to the next step.
Clear the DTCs (Click here).
Repeat steps *1 to *3.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read Current DTCs.
| 5. CHECK FUEL FILTER WARNING LIGHT AND DRAIN WATER |
![]() |
Check the fuel filter warning light.
Drain water.
Remove the air cleaner cap.
Remove the air cleaner case.
![]() |
Loosen the drain plug and place a small tray to catch the water.
| *1 | Drain Plug |
Operate the hand pump until only fuel begins to run out.
Tighten the drain plug by hand.
Install the air cleaner case.
Install the air cleaner cap.