Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR INLET CONTROL SERVO MOTOR

AIR INLET CONTROL SERVO MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR INLET CONTROL SERVO MOTOR


    E127460E02
  1. Inspect the servo motor operation.



      E127461
    1. Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 1, and then check that the arm turns to the "FRESH" side smoothly.

    2. Connect the positive (+) lead from the battery to terminal 1 and negative (-) lead to terminal 5, and then check that the arm turns to the "RECIRCULATION" side smoothly. if the operation is not as specified, replaced the air inlet servo motor.



2. INSTALL BLOWER UNIT ASSEMBLY
  1. Install the blower .