CLUTCH MASTER CYLINDER (for RHD) > INSTALLATION |
| 1. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY |
![]() |
Install the clutch master cylinder with the 2 nuts.
| 2. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE |
![]() |
Using a union nut wrench, connect the flexible hose tube.
| 3. CONNECT CLUTCH RESERVOIR TUBE |
![]() |
Connect the clutch reservoir tube to the clutch master cylinder with the clip.
| 4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag) |
![]() |
Connect the connector.
Install the driver side knee airbag with the 4 bolts.
| 5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) |
![]() |
Attach the 8 claws to install the lower instrument panel finish panel.
Install the 2 screws.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).
| 8. BLEED CLUTCH PIPE LINE |
Fill the brake reservoir with brake fluid and bleed the clutch system.
| 9. CHECK BRAKE FLUID |
Check the brake fluid (Click here).
| 10. CHECK FLUID LEVEL IN RESERVOIR |
![]() |
Check the fluid level and add fluid if necessary.
| 11. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY |
Lift up the floor carpet to expose the asphalt sheet under the pedal.
![]() |
Check that the pedal height is correct.
Adjust the pedal height.
Loosen the lock nut and turn the stopper bolt until the pedal height is within the specified range.
Tighten the lock nut.
![]() |
Check the pedal free play and push rod play.
Depress the clutch pedal until resistance is felt.
Measure the distance between the pedal's released position and the position in the previous step.
Release the pedal. Using your finger, gently press the pedal until resistance increases slightly.
Measure the distance between the pedal's released position and the position in the previous step.
Adjust the pedal free play and push rod play.
Loosen the lock nut and turn the push rod until the pedal free play and push rod play are within the specified ranges.
Tighten the lock nut.
Check the pedal height.
![]() |
Check the clutch release point.
Pull the parking brake lever and use wheel chocks to stabilize the vehicle.
Start the engine and run it at idle.
Without depressing the clutch pedal, slowly move the shift lever to R until the gears contact.
Gently depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) to the full stroke end position.