Home › TRANSMISSION ยท CLUTCH › CLUTCH MASTER CYLINDER (for RHD)

CLUTCH MASTER CYLINDER (for RHD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B129996
  1. Remove the 2 screws.

  1. Detach the 3 claws and remove the cover.



3. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)


B127987
  1. Remove the 4 bolts and driver side knee airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


B132919
  1. Remove the 2 screws.

  1. Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.

    HINT:
    Tape the screwdriver tip before use.



5. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.



6. DISCONNECT CLUTCH RESERVOIR TUBE


C127490E01
  1. Loosen the clip and disconnect the tube from the clutch master cylinder.

    HINT:
    Use a container to catch the fluid.



7. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


C127491E01
  1. Using a union nut wrench, disconnect the flexible hose tube.

    HINT:
    Use a container to catch the fluid.



8. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY


C132128E01
  1. Remove the 2 nuts and clutch master cylinder.