Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


B127906E01
  1. Install the airbag sensor with the 3 bolts.

    Torque:
    17.5 N*m{ 179 kgf*cm , 13 ft.*lbf }

    NOTICE:
    1. If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Connect the airbag sensor connectors.



2. INSTALL REAR CONSOLE BOX ASSEMBLY
  1. Connect the connector.



    B208604
  1. Install the rear console box with the 2 bolts and attach the wire harness clamp.



    B208603
  1. Install the 2 screws.



3. INSTALL NO. 1 INSTRUMENT PANEL BRACKET COVER INNER LH


    B129877
  1. Attach the 2 claws to install the instrument panel bracket cover.



4. INSTALL NO. 1 INSTRUMENT PANEL BRACKET COVER INNER RH


    B129876
  1. Attach the 2 claws to install the instrument panel bracket cover.



5. INSTALL CONSOLE REAR END PANEL


    B129879
  1. Attach the 6 claws to install the console rear end panel.



6. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY


    B208374
  1. Connect the connector.

  1. Attach the 4 clips to install the upper rear console panel.



7. INSTALL CONSOLE CUP HOLDER BOX


    B129881
  1. Attach the 2 clips to install the cup holder box.

  1. Install the 2 screws.



8. INSTALL SWITCH BASE


    B129882
  1. Connect the connectors.

  1. Attach the 2 clips and 2 claws to install the switch base.



9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B216882
  1. Attach the 2 clips and 4 claws to install the upper console panel.



10. INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH


    B208640
  1. Attach the 4 clips to install the upper panel garnish.



11. INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH


    B208641
  1. Attach the 4 clips to install the upper panel garnish.



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


13. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).