Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE RADIATOR SUPPORT OPENING COVER


3. REMOVE FRONT AIRBAG SENSOR LH


B127920E01
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



4. REMOVE FRONT AIRBAG SENSOR RH


B127921E01
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.